Mini-Chat
  • User avatar
    Elektryczny22 - Sun Dec 03, 2017 5:18 am

    Can someone help me with sjson?

  • User avatar
    Haresh Arunachalam - Sun Dec 03, 2017 5:41 am

    Hi can anyone tell me, the maximum current the ESP8266 board’s GPIOs can sink and source. So that I dont end up breaking my ESP8266 board, by giving more than the specification.

  • User avatar
    androidfanboy - Tue Dec 05, 2017 7:50 pm

    12mA source

  • User avatar
  • User avatar
    androidfanboy - Tue Dec 05, 2017 7:51 pm

    sounds like source/sink is the same

  • User avatar
    androidfanboy - Tue Dec 05, 2017 7:51 pm

    Actually, espressif says it can sink 20mA, sorry

  • User avatar
    pavandornadula - Tue Dec 05, 2017 11:40 pm

    Hi , I am using nodemcu dev kit and i am running the sample bmp280 sensor test code . I am getting some fatal exception errors : Fatal exception (0): epc1=0x4021accc, epc2=0x00000000, epc3=0x00000000, excvaddr=0x00000000, depc=0x00000000 . I changed the firmware and baudrate also ?

  • User avatar
    pavandornadula - Tue Dec 05, 2017 11:42 pm

    Can any one suggest any thing to rectify that error?

  • User avatar
    Artanox - Wed Dec 06, 2017 9:42 am

    Hello there

  • User avatar
    Artanox - Wed Dec 06, 2017 9:43 am

    Can i talk with a moderator about a topic submission?

  • User avatar
    AKSHAYKUMAR - Wed Dec 06, 2017 2:20 pm

    hello

  • User avatar
    AKSHAYKUMAR - Wed Dec 06, 2017 2:22 pm

    can anyone tell me how to connect 3 or more then 3 server using esp8266

  • User avatar
    claytonsulivan - Thu Dec 14, 2017 6:28 am

    How to Integrate a Driver (Library) in ESP32 and ESP8266 to work with nRF24L01?

  • User avatar
    rick2nd - Thu Dec 14, 2017 1:52 pm

    i would like to ask a question ( or two ) on the esp8266-01 module

  • User avatar
    rick2nd - Thu Dec 14, 2017 1:58 pm

    ...the baud rate after flashing is 74880 until changed by "user 1 @ 1000" i have tried 115200-no go 9600 version again -no go...

  • User avatar
    rick2nd - Thu Dec 14, 2017 1:58 pm

    what is the baud rate after "user 1 ta

  • User avatar
    rick2nd - Thu Dec 14, 2017 2:00 pm

    tried all of em i can find, same general result.../// as i would expect if i say AT it has to be correct- no guessing or 8266 wount respond

  • User avatar
    rick2nd - Thu Dec 14, 2017 2:07 pm

    ...because i can flash it proves its not communicatiopn or power issues

  • User avatar
    manikanta kothuri - Fri Dec 15, 2017 1:50 am

    Hai

  • User avatar
    manikanta kothuri - Fri Dec 15, 2017 1:51 am

    Hai admin

Who is chatting

No one is chatting  based on users active over the past 15 minutes

Refreshes every 30 seconds
Legend: Administrators, Global moderators