- Fri Aug 26, 2016 11:46 am
#53862
True, works as intended, thought that the LED must be ON all the time. I connected the esp to a arduino to test if I can use the AT commands over the serial monitor. Uploaded the SoftwareSerialExample sketch, put NL & CR and tried changing the baud rate from 9600 to 115200 but I only get gibberish.
It takes about 20-25 seconds for home assistant c[…]
I tried to upgrade tof my sonoff basic R2 with the[…]
a problem Perhaps you want to define "Probl[…]
Rebooting your router will not give you a faster I[…]
There are no other notifications from esptool.py i[…]
Using the Arduino IDE, you'll learn how to set up […]
In this project, you will post to Twitter using an[…]
In this project, we will build a water level contr[…]
I guess I'm late, but I had the same problem and f[…]
Last night I received my first D1 Minis for a lear[…]
Although I am aware that this is an old post, I fe[…]