Page 2 of 2
Re: Sonoff basic with touch switch problem
Posted:
Tue Sep 12, 2017 6:22 pmby malebuffy1977
Did you every managed to make it work?
Re: Sonoff basic with touch switch problem
Posted:
Wed Sep 13, 2017 12:21 amby malebuffy1977
I have the exact problem. Have you ever managed to make it work?
I found that using a china Ac to DC power supply on the breadboard I get same results.
However if I connect a FTDI board and only use its ground Pin and connect that to ground of the breadboard, it works correct even when powering from the AC to DC power supply...
Re: Sonoff basic with touch switch problem
Posted:
Sat Jun 30, 2018 4:40 pmby Aalian khan
I had this same problem but fixed it. These switches turn on our off electrical currents in our body, but in a circuit the are lots of currents all over the place. So what I did is just put rubber behind the switch. What I was using the touch switch for a smart light switch so I attached the other side to a blank plate. I tested it and worked fine.
Re: Sonoff basic with touch switch problem
Posted:
Mon Jul 02, 2018 11:38 amby Aalian khan
Nevermind it started to flicker again after a while