Interpreting UART debug output from SDK
Posted: Tue Jan 16, 2018 12:48 am
Hello all.
I'm getting a lot of messages in the debug UART from the internal code, like
Some of them, I've figurered them out. But not all.
So the question is... Can anyone help me find out more about these messages ? My guess is that it would help me understand why my ESP network is behaving like it is.
Thanks.
I'm getting a lot of messages in the debug UART from the internal code, like
Code: Select all
add 0
aid 3
pm open phy_2,type:2 0 0
cnt
state: 5 -> 0 (0)
rm 0
pm close 7 0 0/9998108
f 0,
scandone
f -180,
scandone
state: 0 -> 2 (b0)
reconnect
state: 2 -> 0 (0)
f 0,
scandone
state: 0 -> 2 (b0)
reconnect
state: 2 -> 0 (0)
f -180,
Some of them, I've figurered them out. But not all.
So the question is... Can anyone help me find out more about these messages ? My guess is that it would help me understand why my ESP network is behaving like it is.
Thanks.