Initial Crash on first UART data being sent on 1st boot.
Posted: Thu May 07, 2020 3:08 pmInitial Crash on first UART data being sent with screen, but only on first flash.
Hi Everyone!
Anyone else have this issue after flashing and sending one char of UART data causing the issue below, After I flash my chip and it crashes, after I reset it manually it works fine, no issues at all, but the moment I flash it for the first time it crashes on data input. Anyone know the cause?
Fatal exception 0(IllegalInstructionCause):
epc1=0x40100014, epc2=0x00000000, epc3=0x00000000, excvaddr=0x00000000, depc=0x0�000000
ets Jan 8 2013,rst cause:2, boot mode:(1,7)
ets Jan 8 2013,rst cause:4, boot mode:(1,7)
wdt reset
Hi Everyone!
Anyone else have this issue after flashing and sending one char of UART data causing the issue below, After I flash my chip and it crashes, after I reset it manually it works fine, no issues at all, but the moment I flash it for the first time it crashes on data input. Anyone know the cause?
Fatal exception 0(IllegalInstructionCause):
epc1=0x40100014, epc2=0x00000000, epc3=0x00000000, excvaddr=0x00000000, depc=0x0�000000
ets Jan 8 2013,rst cause:2, boot mode:(1,7)
ets Jan 8 2013,rst cause:4, boot mode:(1,7)
wdt reset