Re: Help for a correct wiring (with level converter)
Posted: Wed Jan 11, 2017 1:10 pm
I'd try with 3xAA stilo battery HR 15/51 - Ni-MH - 1.2v - 1200mA nominal.
Real (with multimeter), 3.9 V; i'd connected the 3.3V side of the logic level conveter with one1N4007 diode rectifier and I'd measured 3.1V on the pin.
BUT the result still the same!!!
Reset: General Error
Reset: General Error
....
No apparent comunication.
I'd measured also the current I and the reading was 135mA
I try also to work with "reset" line on ESP8266 connected and not connected, i'v try to swap the RX and TX with the only difference that blued led blink continously 1s delay time.
Can some one Help me please?????
Now the power should be OK, why the Test connection doesn't work ?
Real (with multimeter), 3.9 V; i'd connected the 3.3V side of the logic level conveter with one1N4007 diode rectifier and I'd measured 3.1V on the pin.
BUT the result still the same!!!
Reset: General Error
Reset: General Error
....
No apparent comunication.
I'd measured also the current I and the reading was 135mA
I try also to work with "reset" line on ESP8266 connected and not connected, i'v try to swap the RX and TX with the only difference that blued led blink continously 1s delay time.
Can some one Help me please?????
Now the power should be OK, why the Test connection doesn't work ?