ESP8266 Community Forum

- Tue Dec 20, 2022 8:04 am #95657 Hello all I have worked with esp12 f earlier but in this particular module I am not able to enter upload code mode via serial uart gpio 0/15 low and upload code using arduino ide, it simply flashes like the video here and shows a password protected wifi whose SSID is mac address(in my laptop available wifi connections), to mention the module is brand new from seal pack, kindly guide how to flash it using arduino ide which currently isn't flashing it with code

Last edited by aruneshdutta on Tue Dec 20, 2022 12:32 pm, edited 1 time in total.

- Tue Dec 20, 2022 8:54 am #95658 Have you tried to upload code to the board using Arduino IDE? Does Arduino IDE detect your board?

- Tue Dec 20, 2022 12:31 pm #95661

Have you tried to upload code to the board using Arduino IDE? Does Arduino IDE detect your board?

i am using arduino ide only and yes it detects