Needing help with esp8266 and Blynk app.
Posted: Thu Oct 27, 2016 6:47 pm
Hi.
I'm new in the forum,and my laguage is not english,so,sorry for that.I'm going crazy using esp8266-01,Etekcity 433 mhz sockets and Blynk app.I have used ReceiveDemo_Advance ,to sniff the codes which come with the remote controller.Later i have used SendDemo with the sniffed codes,to test the sockets,and they don't works at all.I noticed that the codes they were sent ok,but the pulse length was wrong.Then i have used :
mySwitch.setPulseLength(xxx); using the pulse length of my remote,and sockets works very well.
The problem comes,when i use Blynk app,does no matter,which value i use in PulseLength sentence,always,Blynk sends wrong values,and i know this is critical.
My remote sends codes in a pulse length of 187 microseconds,and the Blynk sends the codes in a pulse length of 351,356,352 or 356 microseconds,and the sockets do not works.
Can anybody hel me with this?
Thanks in advance.
I'm new in the forum,and my laguage is not english,so,sorry for that.I'm going crazy using esp8266-01,Etekcity 433 mhz sockets and Blynk app.I have used ReceiveDemo_Advance ,to sniff the codes which come with the remote controller.Later i have used SendDemo with the sniffed codes,to test the sockets,and they don't works at all.I noticed that the codes they were sent ok,but the pulse length was wrong.Then i have used :
mySwitch.setPulseLength(xxx); using the pulse length of my remote,and sockets works very well.
The problem comes,when i use Blynk app,does no matter,which value i use in PulseLength sentence,always,Blynk sends wrong values,and i know this is critical.
My remote sends codes in a pulse length of 187 microseconds,and the Blynk sends the codes in a pulse length of 351,356,352 or 356 microseconds,and the sockets do not works.
Can anybody hel me with this?
Thanks in advance.