- Wed Apr 13, 2016 2:27 pm
#45438
I used NodeMCU (v2) using Arduino IDE and uploaded code on the board. But now I want to write LUA codes on my NodeMCU board. I failed to connect the ESPlorer IDE with the MCU (using baudrate 9600 and also, 115200). It doesn't show up anything at all. Why this is happening? Any help would be appreciated!
It takes about 20-25 seconds for home assistant c[…]
I tried to upgrade tof my sonoff basic R2 with the[…]
a problem Perhaps you want to define "Probl[…]
Rebooting your router will not give you a faster I[…]
There are no other notifications from esptool.py i[…]
Using the Arduino IDE, you'll learn how to set up […]
In this project, you will post to Twitter using an[…]
In this project, we will build a water level contr[…]
I guess I'm late, but I had the same problem and f[…]
Last night I received my first D1 Minis for a lear[…]
Although I am aware that this is an old post, I fe[…]