ESP8266 Community Forum

- Wed Aug 31, 2016 4:40 pm #54205

I have used every baud rate including 9600 to no avail. Same error message is generated. I am using version 0.1.1.

The current released version of Bounce is 0.4. Can you try with that version? I have made improvements there to serial handling.

- Tue Sep 06, 2016 10:02 pm #54618 All I can find is version 0.1.1, as shown at https://github.com/orionrobots/Bounce.

Where can I obtain version 0.4?

- Tue Sep 06, 2016 10:26 pm #54620 OK... I located v0.4... still giving the same messsage about not running NODEMCU. Happens no matter which Baud rate I select. NodeMCU runs properly with Tera Term, etc. Thanks for any further assistance.

- Fri Sep 16, 2016 1:21 pm #55239

OK... I located v0.4... still giving the same messsage about not running NODEMCU. Happens no matter which Baud rate I select. NodeMCU runs properly with Tera Term, etc. Thanks for any further assistance.

Any ideas?