autodetect firmware
Posted: Tue Jan 17, 2017 10:38 am
After flashing with these settings:
first an erase_flash then,
esptool.py --port /dev/cu.SLAB_USBtoUART w
rite_flash -fm dio -fs 32m -ff 40m 0x0 /esp/nodemcu-dev-7-modules-2017-01-12-16-18-04-integer.bin
I get this in ESPlorer:
PORT OPEN 115200
Communication with MCU..Got answer! Communication with MCU established.
AutoDetect firmware...
Can't autodetect firmware, because proper answer not received (may be unknown firmware).
Please, reset module or continue.
lnn���bp�lrlrlp�n��lbn�|�l�|��b��nn�l��l`�nnl`nr���nr��`p�n�r�����bn�|���b��nn�l`�nnl�l`nr���nbl``�n��b�nl���nn��lp�n�r�����l�bn�|b��nn�l�l`�nnl`nr���n��lr��n��l����n��r��n|�llll`��r�l�l��
NodeMCU 1.5.4.1 build unspecified powered by Lua 5.1.4 on SDK 1.5.4.1(39cb9a32)
lua: cannot open init.lua
Reasons the build is unspecified is because I did the Docker build myself with defaults. It seems to work fine except for the ESPlorer attempting to autodetect the firmware and failing to do so. Is ESPlorer autodetect broken?
first an erase_flash then,
esptool.py --port /dev/cu.SLAB_USBtoUART w
rite_flash -fm dio -fs 32m -ff 40m 0x0 /esp/nodemcu-dev-7-modules-2017-01-12-16-18-04-integer.bin
I get this in ESPlorer:
PORT OPEN 115200
Communication with MCU..Got answer! Communication with MCU established.
AutoDetect firmware...
Can't autodetect firmware, because proper answer not received (may be unknown firmware).
Please, reset module or continue.
lnn���bp�lrlrlp�n��lbn�|�l�|��b��nn�l��l`�nnl`nr���nr��`p�n�r�����bn�|���b��nn�l`�nnl�l`nr���nbl``�n��b�nl���nn��lp�n�r�����l�bn�|b��nn�l�l`�nnl`nr���n��lr��n��l����n��r��n|�llll`��r�l�l��
NodeMCU 1.5.4.1 build unspecified powered by Lua 5.1.4 on SDK 1.5.4.1(39cb9a32)
lua: cannot open init.lua
Reasons the build is unspecified is because I did the Docker build myself with defaults. It seems to work fine except for the ESPlorer attempting to autodetect the firmware and failing to do so. Is ESPlorer autodetect broken?