-->

ESP8266 Community Forum

Open Community Forum for ESP8266, Come share Arduino and IoT (Internet of Things)
https://www.esp8266.com/

Connecting ESP12 for normal function or programming modes

https://www.esp8266.com/viewtopic.php?f=27&t=22424

Page 2 of 2

Re: Connecting ESP12 for normal function or programming mode

PostPosted: Fri Feb 26, 2021 2:43 pm
by sairfan06
I just want to double check minimum pin connection for ESP12 normal run,
below configurations are good?

VCC -> 3.3v
GND -> GND
RST -> Pull up 10K
EN -> Pull up 10K
GPIO15 -> Pull down 10K
GPIO0 -> Pull up 10K
GPIO2 -> Pull up 10K

Please confirm above is minimum requirement to run an ESP12,
thanks

Re: Connecting ESP12 for normal function or programming mode

PostPosted: Sat Feb 27, 2021 3:18 am
by schufti
yes, this seems to be correct
All times are UTC - 5 hours
Page 2 of 2
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/