ESP8266 Community Forum

- Tue Dec 13, 2016 10:51 am #59462

You are actually incorrect, the second edit as you say is a totally different post. If you are going to continue to be petty about edits then just dont reply mate.

I do apologise. I was confused because you posted exactly the same quote above the second post so it looked to be the same post.

David

- Tue Dec 13, 2016 12:05 pm #59464

fit 0.1uF capacitor across the power rails as close to the device as possibleç

RE this, I do remember it came up before just not since discussing the issue at the latest stages, how about physically soldering the capacitor to the VCC and GND pins?

Also the 100uF I mentioned was in relation to the output of the regulator, I did get mixed up on this.

Amazing selection of ESP8266 and ESP32 modules can be found here.

- Tue Dec 13, 2016 12:29 pm #59466 As close to the device as possible so on the pins of the module. I'll leave you to it as I'm off to Switzerland for a few days work.

David

<edit> typo

- Tue Dec 13, 2016 12:47 pm #59467

The problem is ....

Well thank you that was not hard was it

I went in early to work in order to work on my own project but instead I ended up spending that half hour on answering your issue. I would rather have got my own stuff done.