Re: ESP8266 I2C Master to Atting85 I2C Slave issue....need h
Posted: Fri Jan 08, 2016 7:01 pm
Lol...I just realized I did the entire image using a picture of it wired up wrong. When the GND was wired up correctly it still was not working.
I even dug out the oscilloscope and noticed that the slave never responded.
Well I burned a new boot loader onto he Attiny85 to run at 8mhz instead of 1mhz and now it is working.
Any way to make it work with the Attiny85 running at 1mhz instead of 8mhz?
I even dug out the oscilloscope and noticed that the slave never responded.
Well I burned a new boot loader onto he Attiny85 to run at 8mhz instead of 1mhz and now it is working.
Any way to make it work with the Attiny85 running at 1mhz instead of 8mhz?