ONLOAD from previous program carries over to next program
Posted: Fri Jul 29, 2016 4:45 pm
When the onload, [myonloadbranch] is used in a program, it works. But then, if another program (which starts with memclear) is put into the editor, saved, and then run, get message: "Goto Label not found [myonloadbranch]" and the second program does not run. (The second program does not have any onload command in it.)
Workaround: Resetting the nodemcu (esp chip) clears the problem and allows the second program to run.
Workaround: Resetting the nodemcu (esp chip) clears the problem and allows the second program to run.