Re: 3.0 branch available for testing. Report bugs here.
Posted: Sat Jun 04, 2016 7:09 pm
I had been noticing problems with saving programs to the module in ap mode when it was configured for both ap and station mode at the same time.
The change was made for it to exclusively connect to a network or broadcast out an ap.
To support people who wish to run both modes at the same I am putting out a new build. In the new build there is a new command.
Upon execution of this command it will turn on ap and station modes so the ap or connect commands can be used.
I am uploading this new build right now as I type.
The change was made for it to exclusively connect to a network or broadcast out an ap.
To support people who wish to run both modes at the same I am putting out a new build. In the new build there is a new command.
Code: Select all
wifiapsta
ap "MyESP"
wait
Upon execution of this command it will turn on ap and station modes so the ap or connect commands can be used.
I am uploading this new build right now as I type.