Page 22 of 27
Re: 3.0 branch available for testing. Report bugs here.
Posted:
Thu Jun 16, 2016 7:38 pmby russm
Should OTA firmware update work under V3.0? I've tried a couple times with my own web server and it doesn't seem to work. I've only tried NodeMCUs. If there is a guide on setting it up, let me know. I've gone to settings, added OTA URL, saved, then tried an update. Serial connection indicates a fail each time. I connected to my web server and was able to download the binary and use it to USB (serial) flash the NodeMCU.
Re: 3.0 branch available for testing. Report bugs here.
Posted:
Thu Jun 16, 2016 9:35 pmby Mmiscool
The ota updates have been down for a couple of moths since a water pipe in my house burst and damaged the server. Thanks for the reminder that this is some thing i have to get working again.
Re: 3.0 branch available for testing. Report bugs here.
Posted:
Sat Jun 18, 2016 12:00 pmby timathis
Trying to install 3.0.
The old flasher and new flasher have never worked with w7.0 and 2102 usb , and esp12E so I have used espflasher successfully before.
I put espflasher in the same folder as espbasic flasher and ran it apparently successfully for port 27 and 4M .cpp file.
ESP 2 showed in available networks and I connected succesfully.
Problem::::Could not connect to 192.168.4.1
Any clues here.
Re: 3.0 branch available for testing. Report bugs here.
Posted:
Sat Jun 18, 2016 12:24 pmby timathis
Windows diagnostics say
6 The remote device or resource won't accept the connection Detected
The device or resource (192.168.4.2) is not set up to accept connections on port "The World Wide Web service (HTTP)".