ESP8266 Community Forum

Posted: **Mon May 02, 2016 6:58 am**

Managed to upload BASIC on the nEXT EVO board.

Process is straight forward, press Flash button & Reset & Go go.

All nice and dandy BUT:
- No new wifi network available to connect
- on the serial connection I can see the boot image from below:

ESP_Basic_BOOT_1_s.jpg

What's next?

Waiting guidance from Basic users for what to do next

Posted: **Mon May 02, 2016 8:00 am**

connect your browser and point to http://192.168.2.104.

Posted: **Mon May 02, 2016 8:09 am**

As I said is no new WIFI network to connect thru browser in AP mode.

Nothing on 192.168.2.104. And it's make sense as no WIFI network configured yet in client mode, just uploaded a fresh firmware with Basic.

Posted: **Mon May 02, 2016 8:33 am**

Yes, it looks like it's connected to something but there isn't no WIFI network name.
The best is to format the flash disk.
To do that, you can use the same flasher utility but choose the button format instead of firmware.
Then flash again the firmware.
After restart, it should display as an AP mode named ESP.

ESP8266 Community Forum

AC Light Dimmer Using PWM Dimmer Module UPDATED! 3-20-2016

Re: AC Light Dimmer Using PWM Dimmer Module UPDATED! 3-20-20

Re: AC Light Dimmer Using PWM Dimmer Module UPDATED! 3-20-20

Re: AC Light Dimmer Using PWM Dimmer Module UPDATED! 3-20-20

Re: AC Light Dimmer Using PWM Dimmer Module UPDATED! 3-20-20