Re: NEOpixel statement kills IO(SERVO) output for 27 seconds
Posted: Fri Feb 24, 2017 2:55 pm
Or if we can't fix the SERVO command so that it is only affected while NEO data is being sent then would it be possible to modify the PWO statement so that one could specify both the pulse width and the period (frequency) of the pulse?
The PWO output is only affected by NEO while NEO data is being output (unlike the SERVO statement where the servo output is shut off for > 25 sec.) so if we could modify (improve) the PWO statement so it could output a pulse at the rate that a servo wants (with a period of 20ms) then that would take the place of the SERVO statement and be a big improvement.
regards
dwight
The PWO output is only affected by NEO while NEO data is being output (unlike the SERVO statement where the servo output is shut off for > 25 sec.) so if we could modify (improve) the PWO statement so it could output a pulse at the rate that a servo wants (with a period of 20ms) then that would take the place of the SERVO statement and be a big improvement.
regards
dwight