Report Bugs Here

Moderator: Mmiscool

User avatar
By heckler
#66098 I have noticed that if I have a program that crashes the esp module when I do a save... It only causes a crash if I have previously RUN the code and not power cycled the module.

If I power cycle I can SAVE the program numerous times with out a crash.
But if I then RUN the program and then do a SAVE without a power cycle it will crash on a SAVE.

Is there a way to have the SAVE put the module in the same state it is in on a fresh power cycle before it does a SAVE??

For now I always do a power cycle before a SAVE and I have not had any problems.