-->
Page 2 of 2

Re: UART prints garbage

PostPosted: Thu May 21, 2015 6:22 am
by Bravo13
I've posted my code to Github (https://github.com/Bravo13/esp_hello_world) As you can see in utils.c I'm using os_printf like this
Code: Select allos_printf("CHIP : %d | FREQ: %d MHz", chip_id, freq);

Re: UART prints garbage

PostPosted: Thu May 21, 2015 12:10 pm
by cal
Moin,

do you get the standard boot message "load..." at 74880 baud with any firmware?
If not you may not be able to set that baudrate on your serial adapter.

It may select another baud rate it counts as "near" or some use 9600 baud instead.

Cal

Re: UART prints garbage

PostPosted: Fri Sep 11, 2015 5:47 pm
by fshah48
I have the same problem with sysinfo example. Tried all combinations of baud rates, parity and terminal options. Also, I just get a garbled message only on reset NOT after every 3 second(whatever loop delay is?). I even tried to edit the user file to change the baud rate to 57600, built it successfully and encountered exactly same problems.

I am using nodeMCU, it worked well with lualoader, the server example worked well and I was able to toggle the outputs both from the lua terminal and from my cell phone.

I am stuck here and cannot go ahead, please help!!!!