ESP8266 Community Forum

- Tue Jun 30, 2015 10:20 pm #22111 Hi,

Set configuration in user_init, can it solve your problem?

Just like this demo http://bbs.espressif.com/viewtopic.php?f=21&t=227

- Thu Jul 02, 2015 6:01 am #22251 Hi athena:
thanks for your help! unfortunately i can not do this. i need get configure information from other MCU thought UART.
it woring fine with 果云科技's board. it just VCC/ GND/ TxD/RxD. 4 GPIOs: CHIP_EN/RESET/GPIO0/GPIO2.
do there has special requirement for these pins?

- Mon Jul 13, 2015 3:14 am #23118 Do someone known why wifi_softap_set_config_current() failed?
i try put ESP-01 other 6 pins to 果云科技board. just left Tx/Rx in our module. but still get failed.
what's tx/rx GPIO setting for ESP-01?

- Mon Jul 13, 2015 5:15 am #23125 Sorry! the password length is less than 8 chars cause this problem!