ESP8266 Community Forum

Do you want to use it in client or access point mode?

Both are possible and for both you can set SSID and password. The "easy" procedure using a web browser only works for client mode. If you want to use access point mode, you will need to telnet to the device and use the wac (wlan-ap-configure) command, then save (cw) then r (reset).

I corrected the binaries of the release. It appears I picked them from the wrong directory.

eriksl wrote:Do you want to use it in client or access point mode?

Both are possible and for both you can set SSID and password. The "easy" procedure using a web browser only works for client mode. If you want to use access point mode, you will need to telnet to the device and use the wac (wlan-ap-configure) command, then save (cw) then r (reset).

Is this commands in manual are still correct?
I can not find this, what do you wrote now, could you forward here all commands?
A have some problems to put commans in telnet, any asign put in console return unknown command..only ? sign got some result.

to setup Ap send wac "ssid" "pass" nr channel e.g
wac test test 1 correct?