ESP8266 Community Forum

wchpikus wrote:to setup Ap send wac "ssid" "pass" nr channel e.g
wac test test 1 correct?

something wrong with this setup..
i send:
wac test testtest 11, cw,r and i see the network SSID was change, but i can not connect to this network..
Any changing the ssid corresponding to unable to connect..
could you check it?

wac test testtest 11, cw,r

???

You sould use



Then you should write the config (cw) and then reset (r).

eriksl wrote:

wac test testtest 11, cw,r

???

You sould use

Code: Select allwac test testtest 11

Then you should write the config (cw) and then reset (r).

yes, i send it exactly the same.
wac test testtest 11
cw
r
and impossible to connect to test ssid.

What do you get as reply? Immediately after the wac command?