I'm new to ESP8266.
I've read some guides on getting started with them and while they all differ in a few ways, they all say that I should be able to type AT or AT+GMR etc in to the terminal window and get a response. If i reset the device with a BAUD rate of 74800 I get the following in programming mode (GPIO 0 tied to GND):
ets Jan 8 2013,rst cause:2, boot mode:(1,7)
If I remove GPIO 0 from GND i get the following message:
ets Jan 8 2013,rst cause:1, boot mode:(3,6)
load 0x40100000, len 816, room 16
tail 0
chksum 0x8d
load 0x3ffe8000, len 788, room 8
tail 12
chksum 0xcf
ho 0 tail 12 room 4
load 0x3ffe8314, len 288, room 12
tail 4
chksum 0xcf
csum 0xcf
2nd boot version : 1.2
SPI Speed : 80MHz
SPI Mode : DIO
SPI Flash Size : 32Mbit
jump to run usererror user bin flag, flag = c
user code done
I have tried changing BAUD rates and typing AT commands with no success.
The firmware I flashed was:
boot_v1.2.bin - 0x00000
user1.512.new.bin - 0x01000
blank.bin - 0x3E000
blank.bin - 0x7E000
I am using an AI-Thinker ESP8266 12F and I'm completely confused by the above 4 files so any help would be greatly appreciated