Re: Help starting with Arduino Software (IDE) with ESP-12
Posted: Mon Sep 05, 2016 6:47 am
Thanks for you helping. After Connecting D3/GIO0 to ground I was able to upload the sketch. (I also now understand) what pulling up and down mean.
I uploaded the Wifiscan sketch, disconnected the jumper that connected GIO0 to ground, hit reset and can see the following in the serial monitor
scan start
scan done
no network found
I uploaded the Wifiscan sketch, disconnected the jumper that connected GIO0 to ground, hit reset and can see the following in the serial monitor
scan start
scan done
no network found