-->
Page 1 of 1

Setting High Speed PWM on ATTiny85

PostPosted: Mon Jun 26, 2017 5:10 am
by nanawhite107
I am having trouble setting up high speed pwm on my Attiny85. I need to use the PCK, at a speed of 400kHz. I believe that I have followed the data sheet correctly, but for some reason, the timer interrupt flags are not working.

Here is the date sheet of attiny85

If I program the device, the output of the corresponding pin is a constant 5V.

If I comment out the PCK setup and use the system clock instead, the flags are correctly set and PWM works fine. The code is posted. I apologize for the formatting and comments. Any thoughts as to why the flags aren't setting and the PWM isn't working?