ESP8266 Community Forum

- Tue Mar 31, 2015 1:32 pm #13130 mactro
I also tried 1.6.2 and it did not work. 1.6.1 works (but i still cant get i to upload the code)

- Wed Apr 01, 2015 2:07 pm #13213

I can confirm the download is broken

This problem is solved now.

http://www.arduinesp.com

- Wed Apr 01, 2015 2:09 pm #13214

I can confirm the download is broken

The download works again www.arduinesp.com/download

http://www.arduinesp.com

- Wed Apr 01, 2015 2:13 pm #13215

Very nice, but i cant get it to work properly.
I have burned the "bootloader", At version 0.22.0.0, SDK version 1.0.0

I have tried to upload BlinkWifi, with right password and ssid (The ESP8299 have conected to my network prior to the BlinkWifi-program)

In serial monitor, a lot of messages appears. starting with "wdt reset", some "tail", "checksum", "add if=0" and ending with "scandone".

I cant ping it, asuming it has the same IP-adress as before, and there is also no new users in the list at the router.

TX-RX
RX-TX
CH_PD and VCC to external 3.3v power sup.
GND to external power sup
GPIO0 to GND when writing code and "bootloader"

Arduino ISP 1.6.0

Your right, I moved to the core of esp8266\arduino. I will work this example later on. Until that time use the other examples (there are quite a lot of them now)

http://www.arduinesp.com