Chat freely about anything...

User avatar
By Kruu
#63061 Hi,

I use ESP8266-01 with espeasy and domoticz. I have situation to connect door magnet (switch) to gpio0 and GND, a and switch on gpio2 and GND. Everything works fine, I get what I wont from it. If the door is closed I get closed and if door is locked I get locked.

But the problem is when power on the ESP8266 and the door are closed and locked it goes to bootloader mode, right?

I surfed, but cant seem to get where I have to put the resistor to get it working even when the gpio0 is to gnd.

Please advise, thanks.