So you're a Noob? Post your questions here until you graduate! Don't be shy.

User avatar
By wes709
#64157 Thanks for the reply guys ! here is the page where i found the idea ! http://www.instructables.com/id/IoT-Pet ... /?ALLSTEPS

I have no problem following all these steps http://www.instructables.com/id/The-Fir ... DEVKIT-V2/

I just dont know what to do from there on i do notice that i do not have the same board as mentioned in the Iot Pet feeder , however it is still the esp6288 i have all the other electronics so id just need to know where to plug the three servo wires and what to put into the arduino ide

Thanks again for your help guys
User avatar
By Barnabybear
#64203 Hi, looking at the link they only cover 3D printing the food tray and lid that needs to be moved by a servo. Have a look at the link below (or other servo tutorials) as a first step. Once you are happy with the ESP controlling a servo you will need to look at where the control comes from and how to fit into the food dispencer, but get the servo bit sorted first.

http://playground.arduino.cc/Learning/S ... rvoExample
User avatar
By wes709
#64242 Looking at that page , i am told to put the signal wire from the servo to analog pin 1 , but when i look at the pinout diagram for my i see there isnt one :S see the image for the pinout on this instructable. https://www.instructables.com/id/The-Fi ... DEVKIT-V2/