So you're a Noob? Post your questions here until you graduate! Don't be shy.

User avatar
By ilikemyduck
#66051 hey,
im starting my first project with the esp modules. i have a lot of eksperience with arduino but i cant get the esp module to work right. im using 3.3v and a arduino for first testing. every time i press reset i get this message "ets Jan 8 2013,rst cause:2, boot mode:(1,6)" it works fine in all boot modes. but when i try AT commands it just prints "€€€€€€€€" Whats wrong. i have also tried to upload a simple arduino program but then it shows
warning: espcomm_sync failed
error: espcomm_open failed
error: espcomm_upload_mem failed
error: espcomm_upload_mem failed
User avatar
By JackB
#66202 After it finishes booting at 768k baud, it switches to 115k baud in command mode with default settings,
so the trash you see is the 'ready' at 115200 baud.