So you're a Noob? Post your questions here until you graduate! Don't be shy.
User avatar
By 1885
#68060 I have a couple of esp8266 modules 8 pin.

I have been able to get them to work with a Webserver and Blink but now when I try to update the firmware I get the following error when uploading:

warning: espcomm_sync failed
error: espcomm_open failed
error: espcomm_upload_mem failed
error: espcomm_upload_mem failed

Here is the pinout. (no resistors)
Arduino UNO - - - esp8266

TX - - - RX
3.3 V - - - VCC -
GND - - - GPIO 0
NONE - - - RESET
3.3V - - - CH_PD
NONE - - - GPIO 2
RX - - - TX
GND - - - GND

I'd like to control and arduino with 802.11 and use Jonny-five

Help please :)