It's just me or sometimes after uploading a simple sketch (blink led) the code doesn't work (no boot properly) ?
I have to repeat the same procedure a couple times in order to put the code running.
Thank you in advance.
Explore... Chat... Share...
Quick and easy way to get SMOG readings using ESP8[…]
Most inputs on CPUs have the option of using an i[…]
What sort of decoupling capacitors would you recom[…]
The internal bootloader adjust itself to the uploa[…]
Mike/Folks - Do you envisage ever creating a Pulse[…]
As an exercise, I have tried a (fairly rough) port[…]
The process that begins the reconnection lies dee[…]
Thanks a lot !!
Have you checked out the >>New Blog<< […]
So you’re using a 5v bulb? Pete. I think that […]
Try this: https://forum.arduino.cc/in[…]
"I tried to switch off watch dog " how? […]
That's a hell of an ask - essentially you are want[…]
Oh, i didn't even know that they're essentially th[…]
Once the Jeelabs esp-link firmware has been burned[…]
"Am I using interrupts correctly?" The h[…]
There's part of the problem : "1. Scope shows[…]
Yes you can - no arduino required - esp8266 is a f[…]
If you check Espressif Website you will find they […]
Ok, well I'm embarrassed... I just flashed the b[…]