So you're a Noob? Post your questions here until you graduate! Don't be shy.

User avatar
By liderbug
#71872 So I've got a ftd1232 wired to a 8266 chip. I'm not getting anywhere with the ide sw. What board? What other configs? I can get flashing LEDs - 1232 blinks 3x then the 8266 once. This happens 3-4 times and the ide says error on upload.
Pls....
User avatar
By liderbug
#72093 After lots of surf'n and a bloody forehead...
http://arduino-esp8266.readthedocs.io/e ... oards.html
gave me the proper wiring/pu/pd/etc and she loaded and ran

As an aside: because the 8266 board is not .1 oc but 2 mm oc (I think) I built a small jig to hold the board.
Not a bed of nails but praying fingers...
jig1.jpg

jig2.jpg

The pins holding the board are about 90% the width of the board. The pins to the proto are wirewrapped to the pins holding the 8266.

Hope this helps another noob.
You do not have the required permissions to view the files attached to this post.
User avatar
By liderbug
#72174 OK, it works - so I removed the wirewraps, soldered the pins to the daughter board. then soldered in the pins for the run configuration next to the program pins. So now I have a gig, stick the 8266 in the program fingers, upload. Then move to the run fingers and run (tests). (film @ 11)