So you're a Noob? Post your questions here until you graduate! Don't be shy.

User avatar
By schufti
#73256 you do not have to use the buttons if you set the correct board (NodeMCU) .
Trying to use it as "generic" be aware to set DIO mode and nodemcu reset mode.
Speed should be ok up to highest setting.
User avatar
By Merkur
#73259 Thanks for the information. I did check the terminal activity and do not see any communication and I cannot issue any AT commands. I checked this using Putty too.

I am thinking I may have a dead one.

Paul