No SSID when updating design to an ESP-WROOM-02U

A place users can post their projects. If you have a small project and would like your own dedicated place to post and have others chat about it then this is your spot.
 Reply

User avatar

Re: No SSID when updating design to an ESP-WROOM-02U

By jerry.hubbell
- Thu Jun 25, 2020 3:10 pm #87658 After much searching, I was able to piece together a few different messages to figure out that the problem was that I selected QIO instead of DIO as the SPI MODE in the flash tool. Apparently it doesn't work with QIO although I thought it should. Perhaps someone can verify that and look into it.

Thanks

Jerry Hubbell
 Reply
Return to Users Projects