ESP8266 Community Forum

Posted: **Sat Dec 31, 2016 4:18 am**

Thank you for the speed tests!

Concerning your problem: what is your HW? What does the config look like after reset?

If it is the default again, flashing failed. You might try it again with a better power supply, (best with a bigger capacity parallel to Vcc and GND).

Posted: **Sun Jan 01, 2017 2:28 pm**

Hi,
Has in my previous post, with "show" command it shows:

Code: Select allAP: SSID von PW:von23 [Open:0] IP:192.168.4.1/24

even, after reboot (power off and on). So, I assume it saved the new config, but continues as "MyAP" and open.

I will try to compile with hardcoded these settings.

Happy new year.

Posted: **Mon Jan 02, 2017 6:15 pm**

Uploaded a video describing the project.

Posted: **Fri Jan 06, 2017 9:13 am**

What about a command "on/off?
To turn off the "ap_ssid" is just possible by turning off the power, no?

ESP8266 Community Forum

WiFi Repeater (aka. WiFI NAT Router) with Monitoring Port

Re: WiFi Repeater (aka. WiFI NAT Router) with Monitoring Por

Re: WiFi Repeater (aka. WiFI NAT Router) with Monitoring Por

Re: WiFi Repeater (aka. WiFI NAT Router) with Monitoring Por

Re: WiFi Repeater (aka. WiFI NAT Router) with Monitoring Por