Re: nodemcu with TRST-56
Posted: Fri Feb 12, 2021 4:47 pmSorry, i did not get a notification about your question.
i want to make a library for controlling the printer.
The first run was perfect, no network dropping. Every bod came out the printer...
But now i want to update a part of the setup (and i hope it's final).
i want to remove the spi.h plugin if possible, the display works over the spi bus and changing multiple times the printer does not move. I do not know what pin's i can use for hspi but i think it can without it.
Btidey do you have time to assist me with this again?
i want to make a library for controlling the printer.
The first run was perfect, no network dropping. Every bod came out the printer...
But now i want to update a part of the setup (and i hope it's final).
i want to remove the spi.h plugin if possible, the display works over the spi bus and changing multiple times the printer does not move. I do not know what pin's i can use for hspi but i think it can without it.
Btidey do you have time to assist me with this again?
- Switch from node MCU to the TTGO T-display -> i can not get the hspi going
- network system with webinterface for chaning network settings -> 90% done
- Making image printing possible
- Create library for controlling printer