ESP8266 Module not responding to AT commands
Posted: Fri Apr 22, 2016 9:10 amHi All,
We are developing a IoT based Agricultural monitoring system that gets data and then uploads it to thingspeak. We are using an ESP8266 Module to do the data pushing part. Before that we tried to test the module using hyper terminal and serial port. We followed the instructions from this link. The problem is we are not even getting the initial junk data. Please help us to sort out this problem. Is there any problem with the UART voltage we gave? We tried giving a 3.3v UART from LPC2148 board. Please help us futhur with this issue.
We are developing a IoT based Agricultural monitoring system that gets data and then uploads it to thingspeak. We are using an ESP8266 Module to do the data pushing part. Before that we tried to test the module using hyper terminal and serial port. We followed the instructions from this link. The problem is we are not even getting the initial junk data. Please help us to sort out this problem. Is there any problem with the UART voltage we gave? We tried giving a 3.3v UART from LPC2148 board. Please help us futhur with this issue.