- Sun Apr 14, 2019 2:23 am
I'm having the same problem. I'm sorry to reply to this old thread (should i make a new one?), but i followed the instructions given by QuickFix and after i press and release the Reset button on the HUZZAH, my PuTTY-screen displays the following:
Code: Select all
ets Jan 8 2013,rst cause:2, boot mode:(3,6)
load 0x4010f000, len 1384, room 16
I'm a new ESP user and i'm completely lost at this point. I have no experience with PuTTY and i would really appreciate if someone could explain to how to get AT commands working on my HUZZAH.
When i received the HUZZAH, it was preloaded with Lua. I used Arduino IDE 1.8.9 and uploaded a sketch and i think that replaced the Lua that was already on it. But shouldn't it still work? Or do i need to go back to Lua? I'm not sure what to do.
Extra info (maybe it can help to troubleshoot my problem):
I'm using a HUZZAH ESP8266 Breakout board that i purchased over a year ago. The info printed on the ESP housing says: 2AL3B-ESP-F which is different from the picture shown currently on the product page at Adafruit, where it shows: ESP8266MOD. I guess i'm using an old version of the ESP8266?? In that case, maybe i should update the firmware?? How to do that??