Re: ESP-01 resets when switching relay board
Posted: Wed Mar 11, 2015 7:29 am
For the prototype using breadboard removing RST to Vcc might be OK but I wouldn't do it for the final PCB.
The key is proper GND routing: keeping routes as short as possible, separating GND for different functions, having good amount of copper for GND - all the tricks you learn on the way.
I connect RST go Vcc using resistor (few kOhm) and to GND using capacitor (100n - 470n). This constrains the drawn current and gives reset during power up of the circuit.
Regards
M.
The key is proper GND routing: keeping routes as short as possible, separating GND for different functions, having good amount of copper for GND - all the tricks you learn on the way.
I connect RST go Vcc using resistor (few kOhm) and to GND using capacitor (100n - 470n). This constrains the drawn current and gives reset during power up of the circuit.
Regards
M.