ESP8266 Community Forum

Hmmmm... the network is stable if I flash the AT firmware and call



After that I can ping the ESP for hours without one single "host unreachable" message.
The response time is always between 1ms and 3ms.

But as soon as I use the HTTPServer example sketch I am getting the network/temperature problems.
And the response time for a ping varies between 2ms and 180ms.

The same problems occur if I use the DHT11 example code and send my temperatures
to Thingspeak (every minute). Within one hour there are at least three gaps (1-4 minutes long) in the sent data.

I tested the sketches with 8 different ESP8266 modules bought from three different dealers.
All modules are showing the same issue. Not all are getting hot. But there are always timeslots within those the ESP is dead on the WIFI. I can see these events in the access point's log. It tells me "WiFi device is not responding".

Maybe it's not an hardware issue but a firmware bug?!

Can you confirm that your using 10K pullup resistors like in the schematic your provided above ?
(Because if you are shorting the GPIO pins directly to VCC or GND, it can lead to serious problems)
Which firmware are you using for HTTPServer ? Is that the one from ArduinoIDE ?

Hi!

Yes, they are all of 10k, 1%.

And yes, for the web server I am using the example HelloServer from the Arduino IDE. And I never modified the IDE's SDK.

For my temperature client I started with the "DHTtester" sketch and modified it in a way that it sends the data to ThinSpeak.

I've just ran the same HelloServer, working well, and pings are all between 1 and 5 ms.
No over-heating. I don't have much more clues other than you should check power supply again.