ESP8266 Community Forum

Can any one attach the new version of AT commands(V-1.1.1).
vesion-1.1.1 or greater than 0.9.5.2 .
In 0.9.5.2 version,the AT commands are not getting executed properly(some commands work but some don't).
Please help!

Thanks in Advance!!

RichardS wrote:No one has been able to send me or tell me about the base AT command code we should place on the Github, anyone?


Richard.

One command which I feel necessary is for putting in DNS entries, as without which getting onto internet with static IP becomes difficult.
Second command which everyone is missing is - able to broadcast. CIPSEND enables to send message individually, in some situations we are required to send to a group or to all, so this command will be helpful.
Adding command for NTP protocol will also go a long way for using this fantastic module.
Rest of the commands are good enough, alongwith the above suggested commands which can turn this module into a full-fledged one

Anand Burli