Re: Source code changes and samples for new AT+ commands
Posted:
Wed Dec 03, 2014 3:05 pmby igrr
Thanks, i'm checking that out.
I've got a bunch of updates pending, including the new TCP/IP api, so this list will need some updating.
Github is blocked in Russia, so i'm having trouble updating the code and following the issues posted there. Will try to sort that out by setting up a vpn tomorrow.
Re: Source code changes and samples for new AT+ commands
Posted:
Thu Dec 04, 2014 7:36 amby saper_2
igrr wrote:Thanks, i'm checking that out.
Take your time
igrr wrote:Github is blocked in Russia, so i'm having trouble updating the code and following the issues posted there. Will try to sort that out by setting up a vpn tomorrow.
I'll leave this without comment...
Have you tried using proxy server ?
Re: Source code changes and samples for new AT+ commands
Posted:
Mon Dec 08, 2014 1:24 pmby dacb
Any chance we could see a transparent serial to TCP server mode? Right now with the 'official' AT firmware, you can setup a transparent bridge, but only for the client mode. Having a server mode for this would be monumental.
Re: Source code changes and samples for new AT+ commands
Posted:
Tue Dec 09, 2014 8:24 pmby garyservin
There is only one change to be made to get the Server transparent mode, you can see it
here.
I've also asked the same question as an issue in the espressif repo on github but couldn't decipher the
answer properly