- Wed May 03, 2017 10:55 pm
#65528
I'm new to the ESP8266 and had bought the SMT Module because I needed its small form factor and weight. I read I needed to pull up GPIO0 to flash a program, but my iron must have been on too hot and I soldered the trace pad off. Is it still possible to flash programs without GPIO0 pulled high? If so, how?
- Mon May 08, 2017 1:30 pm
#65716
Not as far as I know, no. Without GPIO0 pulled high, the module will just run whatever sketch is loaded.
- Mon May 08, 2017 1:42 pm
#65719
GPIO0 needs to be low in order to program the device. To run the code it needs to be high. If you are not able to control that line then you will not be able to use it.
- Mon May 08, 2017 3:52 pm
#65724
˙uʍop ǝpᴉsdn ʇɐɥʇ ʇoƃ I ʎɹɹoS ˙ʎpnɹ sʞuɐɥ┴
