Thanks in advance,
Explore... Chat... Share...
g6ejd wrote:The espressif data sheet does not give a specification but it says all inputs have a leakage current to maintain an input state of 50nA and you should expect input impedance of any ADC to be high. using 50nA and 1volt maximum input allowed yields 20Mohm which sounds about right to me.
However which ESP8266 implementation are you using because many boards like NodeMCU or WemoS D1 have input resistor diver chains to allow 0-5 inputs and effectively divide that input range down to 0-1volt for the ESP, in which case the input impedance of these boards would be much lower. The Wemos D1 mini for example has a 220K and 100K series divider giving you an input impedance of < 100Kohm.
ESP-01 has 2 usuable GPIO, so it can shift one or […]
Tweeted the question with a link to the thread, ho[…]
I need to wirelessly monitor sensor data, but the […]
Problem solved. The problem is in the memory chip,[…]
Re-read your question, and realized that I seem to[…]
never had a problem with the tp4056 and the esp826[…]
Hi, trying to get the UART communication running b[…]
Hi, My code is very simple, I use my esp8266 as a […]
All the same board - ESP8266-12E, this is the desc[…]
The 'bug' is in the programmer, not the compiler.[…]
Hi Everyone!! I have interface ESP8266 with other[…]
The msgbranch can be used on the esp and app inven[…]
Hi, I use the Arduino core as a great way to progr[…]
@dan: maybe your home internet provider (i-p) uses[…]
Hello, I need to find out the mac address of the[…]
just try #include "Esp.h"
from what I read, wifi is managed via nmi on purpo[…]
I would like to know that, too. What are the prio[…]
I dont find any solution.... :(