Same code and same hardware design. Only change was to reinstall Arduino ide 1.8.5 and libraries after rebuilding my computer.
Anybody have any idea what might be going on? Thanks.
Explore... Chat... Share...
Any way you could upload your OneWire and Dallas […]
esp32 which probably has all the GPIOs you need mi[…]
but I would like to use a library, I'm assuming […]
Buy a development board (they're equally cheap), b[…]
I'm using OTA in AP mode with ESP8266HTTPUpdateSer[…]
Hi everyone , I m working on some project where I […]
I think it warms up in light of the way that cutti[…]
I think I figured out what the problem is. None o[…]
It appears that the issue is with the server not s[…]
Lots of discussion around the max sleep time here:[…]
WiFi settings are stored in flash (or EEPROM, can'[…]
Thanks for response. My earlier reply seems to be […]
The problem has been solved. Apparently, you can't[…]
maybe because it tkaes some time for the 4.2V (vs.[…]
What happens if you run that code on a board that[…]
I had same problem with exception (29). I had pro[…]
Thank you for the reply, I assumed that would be t[…]