im new on esp8266
i just want to make esp8266 as a wifi for my UNO
i have try someway, but still no results.
i have 3 boards wifi :
- 2 pcs ESP8266 07
1 pcs ESP8266 01
i have try all of them and fail when i give AT command (no response)
this is my configuration :
- 3,3V for esp
flasher = esptool.py
firmware = 0.9.5.2.bin
pin config
Vin to 3.3V (arduino or USB TTL)
CH_PD to 3.3V (arduino or USB TTL)
GND to GND Arduino
TX to TX
RX to RX (i have try reverse and TX RX to TX RX is better, nothing shown when i do reverse)
this is the results ESP8266 07
1st run serial monitor
[img]https://lh3.googleusercontent.com/gJUnfzloEhHmg09rqXdVpY4tA2ljmi3HnXsEAWLPFaZ235IwZ041yhp1Cr1msHNyY0WSFLQDeDT5lS7a3oCe=w1366-h662[/img]
2nd reset esp
[img]https://lh4.googleusercontent.com/VYOmF3n5sC53dIw1ZFlwUqOO9xUgofcNXPuMgSBfIRX8g5TeQf2tnDQi4M_pj8Sn2OAaziZgd1Gu7Zy0mRlS=w1366-h662[/img]
3rd rest esp and next will be like this
[img]https://lh6.googleusercontent.com/mFpMpb3XG3yIDgjbEKYOvVX3I5jfuPpaB-UnHNlMFRQsoQkTDaxzxQg4giFtmvPcGdfYR5l8xUGrusTkXVsT=w1366-h662[/img]
i think the firmware is OK, i did it right
i have use another flasher and some firmware the result is same,
no response for AT command,
even the last word is 'READY', but no response.
whats wrong ? please help me, i realy need thiss
![Sad :(](./images/smilies/icon_e_sad.gif)