ESP8266 Community Forum

- Mon Jun 04, 2018 9:37 am #76266 Had finally time to test the ESP01 board.
So the program starts when power goes on and all works when connected to computer with USB programmer module. When i connect 2AA batteries to Ground and VCC, the lights go on, but no e-mail is sent. Should i connect any other pins to Ground or VCC? No GPIO pins are used in program.

- Mon Jun 04, 2018 10:21 am #76269 connect 10k pull-ups to gpio0, gpio2, EN, RST

- Mon Jun 04, 2018 3:49 pm #76280

connect 10k pull-ups to gpio0, gpio2, EN, RST

What You mean by EN? Is it the same as CH_PD?

4pcs 10k resistors from VCC to these pins?

- Mon Jun 04, 2018 5:41 pm #76283

EN? Is it the same as CH_PD?

yes