-->
Page 1 of 1

ESPlorer connection establishment

PostPosted: Sun Jul 08, 2018 8:19 am
by Nicolas BONNIOT
Hello,
My checklist for establishing connection with an ESP8266 devkit is the one below :
    Branch USB cable between computer and devkit
    Start ESPlorer
    Set 115200 bauds and click "Connect"
    Switch on then off RTS button

I wonder about this very last step. If I don't switch on then off the RTS button, nothing happens.
What is the reason about that?

Thanks for your replies,

Re: ESPlorer connection establishment

PostPosted: Mon Jul 09, 2018 2:13 am
by btidey
RTS is normally connected through to reset line of the esp module. So you are resetting the board.